MEP397 Fireye Programmer

Datasheet

The Fireye MEP397 Programmer, 15 sec purge, provides interrupted ignition, interrupted pilot, non re-cycle on flame fail.

The Fireye MEP397 Programmer Modules are used with the Fireye Modular MicroM control. The MEP300 series programmers provide additional enhancements such as early spark termination, pilot proving and interrupted or intermittent pilot operation. These programmers must be used with the MEC320 and MEC480 series chassis. The programmer module incorporates a plugin design for easy installation. The advantages of the Micro M are zero dependence on discrete components previously used for timing functions. The MicroM, through the use of micro-controller technology, incorporates smart diagnostic LED’s, smart reset function for multi-burner applications, optional alpha-numeric display output (ED510) and serial communications via a Modbus Interface. A “check-run” switch is provided on the MEP397 programmer module to assist in testing size and stabilization of the pilot. Flame Failure Response Time (FFRT) is determined by the selection of the amplifier module. Test jacks are also provided on the flame amplifier module to permit flame signal measurement during operation. For proper and safe application of this product, you must refer to Fireye bulletin MC-5000 for a detailed description of the various programmer modules, including installation instructions, amplifier selection, operating sequences for each programmer module, etc.

_{Apex Controls is not affiliated with Fireye or the use of the Fireye logo}