R7848A1008 Honeywell Flame Amplifier

The Honeywell R7848A1008 Flame Amplifier STANDARD. 3S FFRT. RECOMMENDED FOR CYCLED HEATING EQUIPMENT. USE WITH C7015 LEAD SULFIDE Sensor.; Flame Signal Amplifier, 2 Second or 3 Second Flame Failure Response Time, No Self Check, Gas, Oil, Coal: Infrared ( Lead Sulfide ) Flame Sensor C7015, Use with 7800 Series Primary Safety Control, Color: Red, Flame Signal Strength Ranges from 0.0-5 Vdc

Overview

Solid state plug-in amplifiers that respond to flame detector inputs to indicate the presence of flame when used with 7800 SERIES relay modules.

Features

• Flame failure response time of 0.8 or 3.0 seconds.
• Flame signal strength ranges from 0.0 to 5.0 Vdc.
• Plug into 7800 relay module through printed circuit board edge connector keyed for proper orientation.
• Flame signal test jacks to measure amplifier flame signal voltage.
• Color-coded labels identify flame detection type. Dynamic Self-Check Amplifier test the detectors and all electronic components in the flame detection system 7800 SERIES relay module locks out on safety shutdown with flame detection system failure.
• Compatible with existing Honeywell flame detectors (order separately).

Product Specifications

 

Comments	Color: Red
Approvals, Underwriters Laboratories Inc.	Listed: File No. MP268, Guide No. MCCZ
Approvals, Canadian Standards Association	Certified: File No. LR95329-3
Flame Failure Response Time (sec)	0 sec or 3.0 sec
Approvals, Swiss RE	Acceptable
Approvals, Factory Mutual	Approved: Report No. 1V9A0.AF
Self Checking	None (standard)
Use With Primary Safety Control	7800 SERIES Relay Modules
Use With Flame Sensor	Gas, oil, coal: Infrared ( lead sulfide) C7015