The Honeywell R7848A1008 Flame Amplifier STANDARD. 3S FFRT. RECOMMENDED FOR CYCLED HEATING EQUIPMENT. USE WITH C7015 LEAD SULFIDE Sensor.; Flame Signal Amplifier, 2 Second or 3 Second Flame Failure Response Time, No Self Check, Gas, Oil, Coal: Infrared ( Lead Sulfide ) Flame Sensor C7015, Use with 7800 Series Primary Safety Control, Color: Red, Flame Signal Strength Ranges from 0.0-5 Vdc
Overview
Solid state plug-in amplifiers that respond to flame detector inputs to indicate the presence of flame when used with 7800 SERIES relay modules.
Features
- Flame failure response time of 0.8 or 3.0 seconds.
- Flame signal strength ranges from 0.0 to 5.0 Vdc.
- Plug into 7800 relay module through printed circuit board edge connector keyed for proper orientation.
- Flame signal test jacks to measure amplifier flame signal voltage.
- Color-coded labels identify flame detection type. Dynamic Self-Check Amplifier test the detectors and all electronic components in the flame detection system 7800 SERIES relay module locks out on safety shutdown with flame detection system failure.
- Compatible with existing Honeywell flame detectors (order separately).
Product Specifications
Comments | Color: Red |
Approvals, Underwriters Laboratories Inc. | Listed: File No. MP268, Guide No. MCCZ |
Approvals, Canadian Standards Association | Certified: File No. LR95329-3 |
Flame Failure Response Time (sec) | 0 sec or 3.0 sec |
Approvals, Swiss RE | Acceptable |
Approvals, Factory Mutual | Approved: Report No. 1V9A0.AF |
Self Checking | None (standard) |
Use With Primary Safety Control | 7800 SERIES Relay Modules |
Use With Flame Sensor | Gas, oil, coal: Infrared ( lead sulfide) C7015 |