The Honeywell R7847B1072 2 OR 3 SEC Flame FAILURE RESPONSE TIME. FOR USE W/C7012A,C.; Flame Signal Amplifier, 2 Second or 3 Second Flame Failure Response Time, Ampli-Check, Flame Sensor for Gas: Rectifying Flame Rods C7004, C7005, C7007, C7008, C7009 and Q179 for Impedance Matching runs greater than 50′ or Ultraviolet Flame Sensor C7012A and C, Use with 7800 Series Primary Safety Control, Color: Green, Flame Signal Strength Ranges from 0.0-5 Vdc
Overview
Solid state plug-in amplifiers that respond to flame detector inputs to indicate the presence of flame when used with 7800 SERIES relay modules.
Features
- Flame failure response time of 0.8 or 3.0 seconds.
- Flame signal strength ranges from 0.0 to 5.0 Vdc.
- Plug into 7800 relay module through printed circuit board edge connector keyed for proper orientation.
- Flame signal test jacks to measure amplifier flame signal voltage.
- Color-coded labels identify flame detection type. Dynamic Self-Check Amplifier test the detectors and all electronic components in the flame detection system 7800 SERIES relay module locks out on safety shutdown with flame detection system failure.
- Compatible with existing Honeywell flame detectors (order separately).
Product Specifications
Comments | Color: Green |
Approvals, Underwriters Laboratories Inc. | Listed: File No. MP268, Guide No. MCCZ |
Approvals, Canadian Standards Association | Certified: File No. LR95329-3 |
Flame Failure Response Time (sec) | 0 sec or 3.0 sec |
Approvals, Swiss RE | Acceptable |
Approvals, Factory Mutual | Approved: Report No. 1V9A0.AF |
Self Checking | Ampli-Check |
Use With Primary Safety Control | 7800 SERIES Relay Modules |
Use With Flame Sensor | Gas: Rectifying Flame Rods C7004,5,7,8, or 9, Q179 for impedance matching for leadwire runs > 50′ or Ultraviolet Flame Sensor C7012A, C |
Additional Information: Click Here