The Fireye FX50 and FX50-1 servo motors are precision actuators designed to accurately position valves and dampers. The servomotor interprets Modbus commands from an external control and uses a stepper motor to drive to the commanded position. A feedback potentiometer provides continuous positional information that can be read and cross checked by the external control. The FX50 series servo motor offers a maximum output torque of 37lb.-ft./50Nm with a minimum travel time of 30 seconds for 90 degrees of rotation. Maximum rotation angle of the drive shaft is 100 degrees.
The servo is designed to be applied for fuel valves and air damper control on industrial burners. It can also be applied to drive any type of flow control valve or damper as long as the output torque is suited to the application.
Before attempting to install, commission or operate this equipment all relevant sections of this document must be read and fully understood, failure to follow them could damage the product or cause a hazardous condition. If in doubt about any requirements consult the supplier.
TECHNICAL DATA
- Actuating time for 90° angle of rotation: 30 s
- Nominal torque: 37 lb.-ft./ 50 Nm
- revolutions on the output drive shaft: 100°
- Nominal voltage 24 VDC~± 10%
- Nominal power consumption: 20 VA Nominal, 38 VA Peak
- Angle of rotation limited by: Software
- Degree of protection: NEMA 4 IP 65 (Note 1)
- Installation position: Any
- Working temperature range: 32°F – 140°F ( 0°C to + 60°C )
- Duty cycle: 100%
- Weight: 6.10 lb / 2.77 kg
Apex Controls is not affiliated with Fireye or the use of the Fireye logo
Reviews
There are no reviews yet.